Code to Plot data from a file:

• The code basic2.C creates a ntuple for a data file that contains the data distributed in columns.
• The code trans.C take as input two .root files that contain the information of the data set (ntuples) created with the previous code, and create a comparisson plot with these data.
• The code counter.bas reset and initialize the counters in the QIE chip be to tested.
• The code h5_trans.bas register the mantissa per range in the chip and the charge, and creates a data file with this information.

Configure the GUI to take data (aging test)

• Select dut2 as a master device
• Reset the FPGA and other values (QIE, Register,...)
• Redefine the Shadow register with the value: FF80 0E00 0026 1FEF
• Load the Shadow register
• Read the Shadow register (to check if the value is the same that we introduce)
• Star the test
• Select the time interval for the writing of the data and the output file name
• For more information the file QIERadTest (attached files) have all the information related with the test