Miscellany

SCTDAQ

To test hybrids/modules, use SCTDAQ. Download versions of SCTDAQ from here. Instructions for installing SCTDAQ can be found here.

HSIO Setup at UofT

TBA

ATLYS Card Setup at UofT

Issue 1: make sure you have a version of SCTDAQ and ATLYS firmware that works with the ATLYS card and with the type of modules you want to test. We used SCTDAQ version 3574, and firmware atlys_itsdaq_va0b7_ABCN_TTC.bit for ABC250 endcap hybrids.

Issue 2: run NewEndcapHybridSetup.cpp if you are working with endcap modules. EndcapHybridSetup.cpp (the version that came with the software) does not work. We copied over NewEndcapHybridSetup.cpp from our HSIO version of the software, with the necessary changes to allow it to work with the ATLYS card. I've attached the working version to this page. Comment/Uncomment the indicated lines if you want to use it with either HSIO or ATLYS.

List of Presentations

Some useful presentations on the ITK project:

• December 1, 2015: How to Build a Module
• February 24, 2016: Wire Bonding Results (from Dummy module bonding at Celestica)

-- LaurelleMariaVeloce - 2015-12-09