FC7 setup

A nice introductory talk of all the components is available from Mauro Dinardo DAQ School presentation: Hi-resoution_2021_02_DAQ_School.pdf

Shorter version in this Glossary of Module Testing Components GlossaryOfModule-TestingComponents.pdf:

CMS Tracker DAQ Overview

Firmware and software is available at https://gitlab.cern.ch/cmsinnertracker/Ph2_ACF for RD53A. For the CROC you will need to use this version and in both cases the current list of firmware releases can be found here.

Hardware parts required:

• FC7 card
• Imperial College uTCA card
• nano crate
• FMC card - KSU or CERN
• micro SD card
• Power supply for FC7
• Power supply for powering the chip (LV ~10 A Keysight) and dual dig/analog cable
• Power supply for biasing the sensor (~ -500 V ) Keithley and MCX cable for HV connection
• Signal adapter board
• display port to mini display port cable for data communication between module and FMC
• ethernet cable for connecting FC7 to computer
• SFP connector
• Computer to run the Ph2_ACF code (we have tested everything on Centos7 so far at UIC)

Ph2_ACF Installation guide: UIC_Phase_2_ACF_Installation_Guide.pdf

RD53 documentation

RD53B user's guide

RD53B testing twiki

RD53A testing wiki

RD53A manual

Iref trimming manual

RD53 Yarr docs- for connections before powering

Current list of firmware releases

CROC

CROCv1 Testing User Guide

Ph2_ACF Software With CROC Support

System tests

Temperature from NTC can be read using the NTC monitoring pin. Measure the voltage relative to ground and use the Excel sheet attached to this twiki page to convert from mV to degrees C.

UIC Cold Box Documentation

Start Here for an Overview

* Coldbox_PriceList.pdf: This document includes the list of parts with the vendor details and prices in case you want to build your own box.

If you've received a UIC ColdBox , please follow the instructions in the document below to set up the equipment included in the package. This will also help you identify any missing items or additional requirements.

If you've received a Cold box and a Power Supply box from Cornell, here is how you can set it up.

UIC_Coldbox_finalized.pdf

OSU GUI

Software available here

Module Assembly and Testing

Module testing wiki

Standard Operating Procedures:

• Dry storage considerations
• Digital RD53A module assembly
• RD53A module assembly
• RD53A wire bonding
• RD53A module testing

Testbeam at Fermilab (contains details of tuning sensors with FC7)

twiki